HARLEY DAVIDSON SOFTAIL REAR SADDLEBAG GUARDS INSTALLATION MANUAL
download INSTALLATION 1. Remove saddlebag, if equipped, from motorcycle. 2. Remove passenger footpeg or passenger footboard assembly (including footboard mount) from vehicle. 3. See Figure 1. Remove...
View ArticleHarley Davidson Softail Motorcycles EZ-Steer Installation Manual
download Softail EZ-Steer Instruction Supplement Installation of the Champion EZ-Steer system is similar to the installation of the OEM triple clamps of your Harley Davidson Softail Motorcycle. We...
View ArticleHarley Davidson 2004-Up Sportster EZ-Steer Installation Manual
download Installation Notes • Remove front fender, wheel, brake caliper, and fork tubes. • Remove all components attached to stock triple clamps, then the triple clamps themselves. • Remove upper and...
View ArticleHARLEY DAVIDSON CYLINDER BASE COVER INSTALLATION MANUAL
download INSTALLATION 1 is02717 1. Remove crankcase bolt Figure 1. Crankcase bolt location 1. See Figure 1. Remove existing bolt from crankcase. 2. See Figure 2. Obtain the cylinder base cover spacer...
View ArticleHARLEY DAVIDSON LEFT SIDE TOOL BOX KIT INSTALLATION MANUAL
download INSTALLATION NOTE While handling and installing tool box, be careful not to scratch surface. 1. See Figure 1. Attach the toolbox (4) to the toolbox mounting bracket (1) using the three pan...
View ArticleHARLEY DAVIDSON ENGINE/TRANSMISSION INTERFACE AND TOP COVER INSTALLATION MANUAL
download INSTALLATION Perform this installation when the engine is cool. Working on or near the exhaust system when the engine is hot could result in severe burns. (00311a) 1. Refer to the Owner’s...
View ArticleHARLEY DAVIDSON BILLET SHIFTER PEG INSTALLATION MANUAL
download Kit Contents See Figure 1 and Table 1. INSTALLATION 1. Remove and discard the original equipment shifter peg. If needed, use a heat gun to apply heat to the shift lever and shifter peg threads...
View ArticleHarley Davidson Softail Drive Side Brake System Installation Manual
download Removing The Stock Components Although the PM Drive Side Brake System can be installed with the swing arm bolted to the frame, we recommend removing it for better access as well as repainting....
View Article1994 HARLEY DAVIDSON FXD (DYNA) PASSENGER FLOOR BOARDS AND RELOCATION ARMS...
download 1. Beginning on the RIGHT side, use a 9/16″ wrench to remove the bolt from the back of the passenger peg mount. Remove entire peg assembly. 2. Remove the new floorboards and mounts from their...
View ArticleHarley-Davidson XL 883 and 1200 MODELS SADDLEBAG SUPPORT KIT INSTALLATION...
download 1. 1994-99 models: Remove upper shock absorber nut, washer, shock cover and backing washer. Save nut and washer and discard shock cover and backing washer. 2000-03 models: Remove upper shock...
View Article
More Pages to Explore .....